Resource Allocation Indication Parameters

The Resource Allocation Indication (RAI) parameters are described in the table below.

RAI Parameters

Parameter

Description

[EnableRAI]

Enables Resource Available Indication (RAI) alarm generation if the device's busy endpoints exceed a user-defined threshold, configured by the RAIHighThreshold parameter. When enabled and the threshold is crossed, the device sends the SNMP trap, acBoardCallResourcesAlarm.

■

[0] = (Default) Disable

■

[1] = Enable

Note:

■

For the parameter to take effect, a device restart is required.

■

The parameter is applicable only to the Gateway application.

[RAIHighThreshold]

Defines the high threshold percentage of total calls that are active (busy endpoints). When the percentage of the device's busy endpoints exceeds this high threshold, the device sends the SNMP acBoardCallResourcesAlarm alarm trap with a 'major' alarm status.

The range is 0 to 100. The default is 90.

Note:

■

The percentage of busy endpoints is calculated by dividing the number of busy endpoints by the total number of “enabled” endpoints.

■

The parameter is applicable only to the Gateway application.

[RAILowThreshold]

Defines the low threshold percentage of total calls that are active (busy endpoints).
When the percentage of the device's busy endpoints falls below this low threshold, the device sends an SNMP acBoardCallResourcesAlarm alarm trap with a 'cleared' alarm status.

The range is 0 to 100%. The default is 90%.

Note: The parameter is applicable only to the Gateway application.

[RAILoopTime]

Defines the time interval (in seconds) that the device periodically checks call resource availability.

The valid range is 1 to 200. The default is 10.

Note: The parameter is applicable only to the Gateway application.